InFocus Projector SP CEIL 003 User Manual

NOTE: If the (Optional) SP-LTMT-EXT Adjustable height

suspension adapter is a part of the installation, securely install

the ceiling adapter to the ceiling at this time.

SP-CEIL-003

Projector Mount

INSTALLATION INSTRUCTIONS

qStep 3

(Refer to its Installation Instructions)

Install the two (2) conical spacers (J) and two (2) flat washers (K) two

(2) hinge pin screws (L) loosely on both sides of the base box (H).

Raise the projector with the mounting bracket attached and slip though

the hinge pin slots openings on the bracket into the base box. Install the

two (2) angle locking screws (I) adjust the angle, lock it, and then

tighten the hinge pin screws (L).

q Step 1

Invert the projector and place it on a soft and flat surface.

Locate the four (4) 6 (mm) mounting points found on the bottom

of the projector (C). Align and secure the mounting bracket (B)

using the six (6) 8 (mm) x 10 (mm) Phillip screws (A) (supplied).

Do not over tighten!

See Figure 2

See Figure 1

qStep 4

Check all the hardware for proper tightness and security. Do not

over tighten hardware.

qStep 2

Install the base box securely to the ceiling structure in

accordance with proper commercial standards. Use

(commercially available) suitable hardware depending on the

installation requirements.